Primer                                                Gel Cleanser

UV Builder Gel                                   Files

Gel Brush                                          UV Gel Top Coat ( optional)

Buff the nails thoroughly to remove the natural shine.

Apply one layer of primer and let it dry. Then apply a second layer of primer.

Step 2

Using the Gel Brush apply the UV Builder Gel onto your nail. Begin at the cuticle and brush a thin layer right up to the nail tip. Use the same technique as you would use when applying nail polish. Ensure no loose brush hairs stick in the gel. If there are brush hairs, this means you are pressing too hard with the brush.

Step 3

When you have finished brushing on the gel, hold your hands under a UV light for two to three minutes, wait for the get to completely dry. Use a gel cleanser to remove and sticky residue.

Step 4

Put a drop of gel on the nail near the cuticle and slowly spread it over the entire nail from the cuticle to the nail tip as you did in step 2.

Step 5

Hold your hands again under the UV light to dry the gel and clean any residue with gel cleanser.

Step 6

Put another drop of gel on the nail and this time while spreading the gel make sure you get an even gel-like uniformity.

Step 7

Hold your hands again under the UV light to dry the gel and clean any residue with gel cleanser.

Step 8

When the gel has dried completely. Shape your nails with a nail file as per your desire.

Step 9 (optional)

For extra shine use one coat of tack free UV Gel topcoat. Dry for two minutes.

IMPORTANT NOTES:

1.     While applying the gel, to avoid the nail from lifting later, make sure the gel does not come in contact with your skin.

2.     Too much gel on the nail will cause uneven curing or air bubbles to form.